Cooper Motion Sensor Light Switch Instructions

Set the switch to the auto mode.

Cooper motion sensor light switch instructions.

When unit stabilizes about 1 minute the sensor is ready to detect motion. Select a location that is 6 to 8 feet above ground level. In manual on mode the lights are turned on by pressing the pushbutton. Apply power and wait one minute.

Turn the light switch to the off position for 40 seconds and then turn back to the on position. Turn the power back on at the circuit breaker. Turn off power at the main fuse or breaker box. The sensor blue wire is not used and should be capped off with a wire nut.

In either mode the. Motion is detected the lights will turn on. The sensor black wire will connect to the hot wire in the wallbox. The sensor red wire will connect to the wire which goes to the light fixture.

Install the sensor loosely using the mounting screws provided. Automatically release the button while the led is blinking. Make sure the sensor is not picking up moving objects such as trees traffic etc. Repeat this procedure to restore normal operation.

Unit is in override mode if there is no motion. Turn the light control knob all the way clockwise to the moon symbol dusk position fig. Switch or in the unlikely event of a failure of the motion sensor. Rotating the light adjustment knob will control at what level of brightness the motion sensor will turn the light on when it is in automatic mode not test mode.

Instructions for a cooper outdoor motion detector location. Two locations one location is the sensor and the other location is a standard 3 way switch two locations replace both 3 way switches with sensors in automatic on mode the lights turn on automatically when a person enters the room. Match up screw holes on the cover plate with the junction. Install your fixture near a doorway or pathway to.

The lights will turn off 5 seconds after motion is no longer detected. The sensor green wire will connect to the ground wire in the wallbox.