Cord Drawn Curtain Tracks Instructions

Cord on overlap master carrier as original.

Cord drawn curtain tracks instructions.

Draw the cord until the right hand carrier 1 is as far to the right as possible. Tension cord and tie off h. I have fitted a metal white curtain track with cord attachments and runners but finding it very difficult to correctly hang the curtains problem overlaper runner hope you can help pulling my hair out thanks. How to fit new cord to curtain tracks take measurements.

Next place the rod face down on a flat surface. 8conversion to one way draw right hand conversion drapes drawn from left to right 1 lay track face down on the floor. 2 pull track apart at the centre. Standard drill bits work fine on all aluminum tracks.

Replace sliders at each end. Re attach track onto brackets and re hang curtains. Holding the cords taut push carrier 2 as far to the left as possible. If you re removing an old cord you can untie it.

Once you have worked out were your track is going to go. Curtain track features and how to install. 3 unhook cord from master carrier and allow to drop inside track. First you ll want to remove the curtain along with the curtain hooks from the rod and carriers.

Remove the curtains from the traverse rods so you can access the cording. Fitting instructions for styletrack track if installing into plaster or wallboard where possible try and pick up a timber stud. Pass the cord over the central bridge on slave master slide f twist cord to create a loop and hook over centre tab f pass cord over the top of the bottom pulley in opposite end pulley. How to thread cord on curtain rails.

To drill holes identify where the holes should be positioned and mark the track. Click here for how to mend it. Measure the rod s length while it is still on the wall. Add those two.

Place pulley 2 onto track section and secure with screws. If unable to locate a timber stud use a suitable wall plug or toggle for hollow walls to hold your bracket. Installing your styletrack curtain track. Most curtain tracks do not have the mounting holes pre drilled.

Using a small bit drill pilot holes centered in the slot through the top of the track. Remove the curtain rod from the. Then feed cord around and over the top pulley g pass cord back through ovelrap master slide.